Replacement sleigh runners for empire blow mold Santa
3d printed replacement sleigh runners/rails for empire/General foam sleigh. These are 3d printed in gold similar to the original and very durable, however they are still plastic and can break. They are thicker than the originals and one inch shorter, but the same length. The design varies slightly from from the original to give them durability but also make them printable. Couple of notes: there are a total of eight mounting holes in the top, two of which line up with originals so if the bottom holes are still intact on your sleigh, you can re use them. The holes for the spacers are also placed to line up with the originals. If you don''t have originals you can use a piece of 1/4 inch threaded rod. Unfortunately due to the style of printer these are made on (there is currently only one that can do an object this long) there is a "good side" and a "not so good side" so I recommend telling me if you have your sleigh left facing or right facing, and I will print them so that you have nice